The term ‘flooded motor’ means the engine has an excessive amount of fuel and the fuel has fouled the spark plugs causing the engine to be very hard to start or not run at all.
It is rather simple to clear out a flooded motor. Merely lift the warm up lever (fast idle, throttle arm) so far as it goes and crank the engine with no choke. By doing this you provide lots of air to the engine which basically flushes the additional fuel away clearing the plugs permitting them to spark once more and start the engine.
Completely different motors have completely different ways of engaging the warm up lever; some have a separate lever to the main control arm. Some engines have a button on the management arm that you simply push in so you possibly can throttle the engine in neutral, some motors you must pull the control arm out to disengage the gear shift. Find out which ever way your management arm works and have a play.
Run your motor (make certain it within the water or on flushing muffs) and hold the choke on until it dies, (either by pushing in the key or holding the choke switch.) This will flood the motor. To make certain it is really flooded; keep holding the choke on and attempt to start it, it ought to be not possible to start!
Now simply give it full throttle on the warm up lever, and with NO choke crank the engine… It’d take a few seconds or a few attempts however it will start. As soon as started, keep the warm up lever up until the motor runs smoothly. Be careful not to over rev the engine. You might must decrease the warm up lever to keep the RPMs under approx 2000rpm. It will be very Smokey for a while.
It is a good suggestion to practise totally different ways of starting your motor in numerous eventualities, just in case. You by no means know in the future you might be drifting towards the rocks and in a panic you forget your engine is already hot and does not want choking, in case you choke a scorching engine it is very easy to flood it. Sp practise flooding it and attempting to start it once more, someday it would possibly save you…
If you have any type of inquiries relating to where and how you can use maintaining outboard blog, you could contact us at our own webpage.